The new EMI standards for emissions is now affecting more companies as they replace existing products with new lines which must fully comply to the standard. The task of passing EMI compliance is made easier thanks to Warth's HUGE range of shielding products.

Typical panel sealing applications use Zemrex and Fabshield products from the range which feature a conductive fabric or mesh wrapped over a soft core material as examples show.

FABSHIELD
Conductive fabric over soft elastomer core
High performance EMC protection
Self termination without fraying
Low compression resistance
Dust and moisture protection
Standard and custom profiles

Zemrex ME
Knitted wire mesh over elastomer tube or sponge core for use on enclosure doors & cabinets
118dB at 10MHz
Moderate compression resistance
Range of wire types
Standard and custom profiles

Zemrex MS
Knitted all-wire mesh gasket strips for use on enclosure doors and cabinets
124dB at 10MHz
Range of wire types
Standard and custom profiles
High temperature operation

Zemrex MG
Combination gasket. Knitted shield bonded to an elastomer carrier
118dB at 10MHz
Various wires and elastomers available
Environmental protection up to IP65
Self adhesive option
Standard and custom profiles

ZEMREX KNITWRAP
Knitted wire tape for cable wrap shielding
62dB at 10 MHz
Various wire types available
From stock in 15, 25, 50 and 75 mm widths
Provides mechanical support and protection

 Valor Electronics designs and manufactures a high reliability range of PCB transformer/choke/filter modules for computer and telecommunication applications.

The FALCON series connector modules have recently been added to their range, giving signal integrity at every stage of transmission.

The MD6301 is a single 10/100 BASE-TX filter connector module that features:

  • Fully shielded magnetics to protect data from internally generated digital noise
  • Reduces the overall length of the signal path for improved common mode performance
  • Implements full common mode termination scheme with used and unused twisted pairs
  • Meets IEEE802.3 Baseline Wander Compensation specification
  • Integrates high voltage capacitor to chassis ground
  • Supports all major transceivers with matched turns ratios and complete integration of specified termination
The MD6304 is a Quad 10/100 BASE-TX filtered module version that has the same features and performance as the single unit.
Click here to request further information on our range of Electrostatic Shielding Solutions, or the Valor Electronics PCB transformer filter modules.

Mainpage | Page 1 | Page 2 | Page 3 | Page 4

CLARKE & SEVERN ELECTRONICS
4/8A Kookaburra Road,
Hornsby, NSW Australia 2077
Ph: +61 2 9482 1944 Fax: +61 2 9482 1309
www.clarke.com.au
©1996, 1997 All rights reserved. Buynet is the registered Trade Mark of Internet Buynet. All brand names, registered trade names, trade marks and individual site contents are the property of the company concerned. Mirroring of any Buynet site is strictly prohibited without permission of Buynet.